Conext Gateway Installation
Figure 22Sample Device Overview screen - List display
To change a device setting:
1. In the main menu bar, click Devices. See Figure 21 for a sample of the default display
of all connected devices.
2. If you want a shorter list of devices, switch to a List display. See Figure 22.
3. Put the device in to Standby mode first.
a. Click a device you want to put in to Standby mode.
b. Click Configuration>Controls.
Note that Controls may be called differently such as AGS Control.
c. Search for the control setting Operating Mode.
d. Select Standby.
e. Click Apply.
4. Click Configuration
5. Choose either Basic or Advanced settings.
6. Click a device setting category. For example, Inverter Settings in the case of an
inverter device.
7. Change a specific setting by selecting from a drop down list, toggling a switch, or
entering a different value.
8. Click Apply to save the changes.
9. Use the Operating Mode menu to put the device back into normal operating mode.
Configuration Conext Gateway Conext Gateway Owner's Guide
975-0806-01-01 44