Conext Gateway Installation
Features
NOTE: Specifications subject to change without prior notice.
Programmable dry contact relay Screw 3-terminal, 16-24 AWG, NC-Com-NO, Form:
Class 2, 24 V DC, 4 A max SELV input only
Web-base user interface Internet Browser
Remote firmware upgrades Yes (Conext Gateway and connected Xanbus
devices)
Custom Data logger Yes (requires Micro-SD card)
Micro-SD card (supplied) 8GB
Regulatory
NOTE: Specifications subject to change without prior notice.
EMC immunity
EN61000-6-1EN 55035
EN 301 489-1, -17
EMC emissions
EN61000-6-3EN 55032
EN 301 489-1, -17
FCC part 15BICES-003
Substances / environmental
RoHS
FCC ID
Contains 2AODL-CONEXTGTWY
IC ID
Contains 24209-CONEXTGTWY
Model number
865-0329
FCC Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
n Reorient or relocate the receiving antenna.
n Increase the separation between the equipment and receiver.
Specifications Conext Gateway Conext Gateway Owner's Guide
975-0806-01-01 58