Additional Info

975-0690-01-01 Rev-B
07-2014
3
www.SEsolar.com
Conext™ Battery Monitor
865-1080-01
MAIN

MAIN

F
Pre-scaler board
Battery shunt
Pre-scaler board
SYNCHRONIZE
MAIN
SYNCHRONIZE
A
–
MAIN
SYNCHRONIZE
G
H
B
A
C
D
E
F
H
G
SYSTEM
BATTERY
H FC
D
E
G
A
B
●
●
●
●
●
SYSTEM
BATTERY
V+ (Red wire)
V– (Black wire)
Vm+ (Brown wire)
Vm (Grey wire)
Va2- ( ellow wire)
Va1+ (Orange wire)
I+ (Blue wire)
– iolet wire)
To wire the Battery Monitor:
Connect the battery sense cable wires to the battery terminals, as shown above.
Wire the battery shunt to the battery, as shown above.
Install 1AT fuses as close to the battery terminals as possible, as shown above.
Connect the Battery Temperature Sensor to the battery bank, as shown below.
Connect Xanbus cables to your Xanbus network and Pre-scaler cable (orange)
to the pre-scaler board, as shown below.
–
Y
l (V
Battery sense
cable
Battery enclosure
Battery
Temperature
Sensor
Twisted pair
2x 1 fuseAT fuse
AT fuse
Battery shunt
To inverter/charger
To auxiliary battery
To Battery shunt
and batteries
(see diagram at
top of this page)
To Xanbus
network
To batteries
(see diagram at
top of this page)
OR
MAIN MENU
Enter the Main menu by holding for three seconds, until  appears on the display
screen. From the Main menu, you can navigate to different menus, including the Function
menu (see Function Menu, below).
FUNCTION MENU
From the Main menu, enter the Function menu by pressing twice, until 
appears on the display screen.
Use and buttons to browse through the different Functions. Press to view
the selected Function value.
Use and to change the value. Press again to return to the Function menu.
DISPLAY MODE
Access the Display Mode from any menu item by pressing for three seconds. This will
save any Function value changes to internal memory. When no navigation buttons are
pressed for 90 seconds while operating in the Function menu, the Battery Monitor will
automatically return to the Display Mode without saving any Function value changes.
For information about other menus, see the Conext Battery Monitor Owner’s Guide
available at www.SEsolar.com
Hold the and buttons until
SYNCHRONIZE flashes on the display screen.
NAVIGATION BUTTONS
Use the navigation buttons on the Conext Battery Monitor to scroll through menu screens,
check battery status and change configuration settings.
NOTE: Before synchronizing the Battery Monitor to a state of charge of 100%, charge
the batteries completely and allow the batteries to remain in float state for two hours or
longer after first installation.
Left Select Right
AT1
1
Cable Connections
Synchronize
Menu Navigation