Conext Configuration Tool Manual

Configuring the System Control Panel
975-0720-01-01 3–33
This manual is for use by qualified personnel only
Saving and Restoring Configurations
Save Configuration allows you to save the current AGS configuration. Restore
Configuration allows you to restore a previously saved configuration from a file.
See “Restoring a Configuration” on page 2–32 for further details.
Configuring the System Control Panel
The following section describes how to configure the System Control Panel (SCP)
to suit your preferences and the requirements of the Xanbus system.
To configure the SCP:
1. On the main screen, click the SCP icon:
The SCP Basic Status window opens.
2. In the Basic Status window, click Configure
3. Click Basic Configuration.
Basic Status
The Basic Status window shows the network status of the SCP.
Generator
Association
This generator name is used by the Conext XW+ to identify which generator is
connected to either of the two AC inputs, AC1 or AC2. It is only necessary to change
this setting in installations with more than one AGS in a system. In this case, the
Generator name on each AGS needs to be unique.
For example, if a generator is connected to AC2 on an Conext XW+, the generator
name (e.g. Gen1, Gen2, etc.) selected for AC2 under Connections on the Conext
XW+ must match the generator name assigned here.
Table 3-13 AGS Trigger Settings
Setting Description
Figure 3-29 SCP Basic Status Window