Conext Configuration Tool Manual

Configuring the Conext Battery Monitor
975-0720-01-01 3–41
This manual is for use by qualified personnel only
Modbus Configuration
Battery Monitor Modbus settings are configurable from the Battery Monitor
Configure menu. For more information about Modbus Settings and Modbus
Maps, see the Conext Battery Monitor Owner’s Guide.
WARNING
UNINTENDED OPERATION
The use of this product with Modbus communications requires expertise in the
design, operation, and programming of the device. Only qualified persons
should program, install, alter, and commission this product. When writing
values to the device, you must ensure other persons are not working with the
device.
Failure to follow these instructions can result in death or serious injury,
and/or equipment damage.
Figure 3-36 Battery Monitor Modbus Configuration
Setting Description
RS485 Address Sets the address of the Battery Monitor.
RS485 Baud Rate Sets the baud rate of the Battery Monitor.
RS485 Parity Sets the parity of the Battery Monitor.
RS485 Stop Bits Sets the stop bits for the Battery Monitor.
Modbus Byte
Order
Sets the Modbus byte order. The first byte contains MSB (Big-Endian).