Conext Configuration Tool Manual

Starting Firmware Upgrade
975-0720-01-01 5–3
This manual is for use by qualified personnel only
To upgrade Conext Configuration Tool firmware:
1. Power down Xanbus devices that are not intended to be updated. This
reduces network traffic and speeds up the update process.
2. Click Firmware Upgrade.
3. A warning box appears, as shown below.
Upgrading the firmware causes all devices to stop power conversion and
enter standby mode as a safety feature. Power conversion can be resumed
after the upgrades are complete.
To proceed with the firmware upgrade, click OK.
4. Select the folder that contains your saved firmware files, for example
C:\User\AppData\Roaming\CnxtCfgTool\Firmware. For more information, see
“Downloading Firmware Files” on page 5–2.
Note: Firmware files are listed in order of their version number (oldest to newest).
If a file is more recent than the device’s version, it is automatically selected. If you
would prefer to load a previous version of the firmware, or reload your current
version, select the appropriate check box.
To proceed upgrading your selection of files for devices, click Upgrade. If you
have selected an older firmware version, a warning message prompts you to
proceed.
Figure 5-2 Firmware file versions