Conext Configuration Tool Manual

Introduction and Installation
1–2 975-0720-01-01
This manual is for use by qualified personnel only
Introducing Conext Configuration Tool
Conext Configuration Tool is a PC-based software tool for configuring Conext
SW/XW/XW+ Inverter/Charger Systems on a Xanbus™ network.
Conext Configuration Tool is not intended to replace the Conext System Control
Panel (SCP), but it does incorporate the same configuration settings, while
simplifying the task of system configuration. You will still require the SCP to
monitor inverter/chargers and other devices on your Xanbus network.
Conext Configuration Tool Functions
Conext Configuration Tool functions include:
• System Configuration. Use the Configuration Wizards to quickly get your
system up and running.
• Device Configuration. Configure individual settings for Xanbus network
devices, including Conext XW+, Conext XW, and Conext SW Inverter/
Chargers, Conext MPPT 80 600 and Conext MPPT 60 150 Solar Charge
Controllers, Conext System Control Panel, Conext Automatic Generator Start,
and Conext Battery Monitor.
Before using Conext Configuration Tool, familiarize yourself with the installation
and operation of the Conext XW+ Inverter/Charger and other devices on your
Xanbus network. For more information, see the Conext XW+ Inverter/Charger
Installation Guide and the Conext XW+ Inverter/Charger Owner’s Guide.
System and Hardware Requirements
To install and operate Conext Configuration Tool, you will need a laptop or
personal computer running Windows XP (SP3 or later), Windows Vista or
Windows 7/8/10.
You will also need an available Universal Serial Bus (USB) port on your computer.
Before installing Conext Configuration Tool, ensure your computer’s USB hub is
installed and working properly.