Conext Configuration Tool Manual

Installing Conext Configuration Tool
975-0720-01-01 1–5
This manual is for use by qualified personnel only
Installing Conext Configuration Tool
To install Conext Configuration Tool, you will need to perform all of the following
steps:
1. Install the USB-to-Xanbus adapter driver software on your computer.
2. Connect the USB-to-Xanbus adapter to your computer.
3. Configure the USB-to-Xanbus adapter driver software.
Note: Perform step 3 before running Conext Configuration Tool for the first
time.
4. Connect the USB-to-Xanbus adapter to the Xanbus network.
5. Install the Conext Configuration Tool software on your computer.
Installing the USB-to-Xanbus Adapter Driver Software
Before you connect the USB-to-Xanbus adapter, you must install the driver
software.
To install the USB-to-Xanbus adapter driver software:
1. Insert the Installation USB flash drive into an available USB port on your
computer.
Note: Ensure that you are logged in with administrator privileges and that
Windows Explorer shows all file extensions.
2. Open Windows Explorer or equivalent file browser and navigate to the
Installation USB flash drive.
3. To start the installation process, double-click the file named
isCan Multidriver_v5.3.0002_Setup.exe.
4. Follow the step-by step instructions provided by the Windows InstallShield
Wizard.
5. When the installation is complete, click Finish.
6. Reboot your computer.