Conext Configuration Tool Manual

Introduction and Installation
1–6 975-0720-01-01
This manual is for use by qualified personnel only
Connecting the USB-to-Xanbus Adapter to Your Computer
To connect the USB-to-Xanbus adapter:
1. Connect the built-in USB cable of the USB-to-Xanbus adapter to an available
USB port on your computer.
2. When it is connected, a green LED indicates the presence of the operating
voltage and flashes during the start-up/reset process.
Note: A red LED indicates an error during start-up/reset by flashing three
times.
3. If a “Found New Hardware” message or Wizard appears in the status area of
your desktop, close it.
4. Proceed to “Configuring the USB-to-Xanbus Adapter Driver Software”.
Configuring the USB-to-Xanbus Adapter Driver Software
Before you can operate Conext Configuration Tool, you must configure the USB-
to-Xanbus adapter driver software.
To configure the USB-to-Xanbus adapter driver software:
1. With the USB-to-Xanbus adapter connected to your computer, run Start > All
Programs > ifak system > CAN > isCAN driver config.
2. Click Add.