Conext Configuration Tool Manual

Introduction and Installation
1–10 975-0720-01-01
This manual is for use by qualified personnel only
Note: Ensure that the USB-to-Xanbus adapter pins are properly aligned with
the Xanbus converter pin holes before tightening the Xanbus converter
screws.
3. Connect the other end of the Xanbus cable to an open port
on the Xanbus
network. (See Figure 1-6 on page 1–11 for an example of a Xanbus network
with the USB-to-Xanbus adapter connected.)
Note: The Xanbus network must be terminated at both ends. The USB-to-
Xanbus adapter has a built-in termination feature, activated by a switch on
the Xanbus converter. For more information, see “Network termination” on
page 1–11.
4. Reconnect AC and DC power to the inverter/charger and power back on as
necessary.
Figure 1-5 Connect Xanbus Converter to USB-to-Xanbus Adapter
Xanbus converter
USB-to-Xanbus
adapter
Included Xanbus cable