Conext Configuration Tool Manual

Introduction and Installation
1–14 975-0720-01-01
This manual is for use by qualified personnel only
11. An information screen appears, as shown below.
To complete the current Conext Configuration Tool installation, click Next.
12. When the Setup Wizard has finished installing Conext Configuration Tool,
click Finish.
If Launch Conext Configuration Tool is selected, Conext Configuration Tool
will start after you click Finish.
Note: Before launching Conext Configuration Tool, ensure that the device
driver software for the USB-to-Xanbus adapter is installed and configured.
See “Installing the USB-to-Xanbus Adapter Driver Software” on page 1–5.
To verify your installation, find Conext Configuration Tool on your Start Menu.
By default, Conext Configuration Tool should appear on your Start Menu
under All Programs > Conext Tools > Conext Configuration Tool.