Conext Configuration Tool Manual
Introduction and Installation
1–16 975-0720-01-01
This manual is for use by qualified personnel only
3. Configure the Conext Automatic Generator Start. See “Configuring the
Conext Automatic Generator Start” on page 3–27.
4. Save the current configuration settings. See “Saving the System
Configuration” on page 3–4.
Main Screen Features and Commands
After Conext Configuration Tool starts, the main screen appears. The main
screen lists all devices in the Xanbus network. As shown in Figure 1-9, the model
name, device type and number, and node address of each device is displayed.
From the main screen you can click a device icon to open the status and
configuration windows for the selected device. For information about configuring
each device individually, see Chapter 3, “Device Configuration”.
From the main screen, use the Control, Configure and View menus to view and
change system configuration settings.
Note: Do not attempt to make adjustments to the system using the System
Control Panel or the front panels of any devices while using Conext Configuration
Too l.
Control Menu Features:
• Change the system mode using the Mode Menu
• Enable/Disable inverting using the Invert Menu
• Enable/Disable charging using the Charge Menu
• Clear all faults/warnings
• Enable Broadcasts
• Exit the Conext Configuration Tool
Configure Menu Features:
• Set the Connection Names
• Open a Configuration Wizard
• Toggle Temperature Units
Figure 1-9 Control Menu