Conext Configuration Tool Manual

Introduction and Installation
1–18 975-0720-01-01
This manual is for use by qualified personnel only
Charge
Use this feature to enable or disable charging on all applicable devices.
Clear All Faults/Warnings
To clear all system faults and warnings, click Clear All Faults/Warnings.
Enable Broadcasts
Use Enable Broadcasts to re-enable Xanbus network messages. See Chapter 5,
“Upgrading Firmware”.
Exit
To quit Conext Configuration Tool, click Exit.
Configure Menu Features
Connection Names
If you have a Conext System Control Panel (SCP) on your Xanbus network, you
can easily change the system connection names by using Connection Names.
Note: This feature is only available if an SCP is installed on your Xanbus network.
To set the connection names:
1. In the Configure menu, click Connection Names.
2. Click the tab for the type of association you wish to set (Grids, AC Loads,
Generators, Batteries, or Solar Arrays).