Conext Configuration Tool Manual

Introduction and Installation
1–20 975-0720-01-01
This manual is for use by qualified personnel only
Firmware Upgrade
To upgrade the firmware in a device, use Firmware Upgrade. For more
information, see Chapter 5, “Upgrading Firmware”.
Convert Phase
Use Convert Phase to convert a Conext XW+ Inverter/Charger’s output phase
from single to split phase, or vice versa.
Note: This feature is available on Conext XW+ Inverter/Chargers only.
Save Configuration
You can save the system configuration at any time. For more information, see
“Saving the System Configuration” on page 3–4.
Restore Configuration
You can choose a previously saved or downloaded system configuration file that
contains settings for all devices. For more information, see “Restoring a
Configuration” on page 2–32.
Figure 1-13 Firmware Upgrade
Figure 1-14 Convert Phase