Conext Configuration Tool Manual

Using the Configuration Wizard
975-0720-01-01 2–3
This manual is for use by qualified personnel only
Using the Configuration Wizard
1. Start the Configuration Wizard: On the Configure menu, click Configuration
Wizard.
Click I Understand and Accept after reading the message.
2. Select your desired Configuration method: Quick, Detailed or Multi-Cluster.
To determine which method to select, refer to the differences between the
three configuration methods in “About the Configuration Wizards” on
page 2–2.
Note: When commissioning a new system, the Quick System Configuration
Method is recommended.
WARNING
HAZARD OF PHYSICAL INJURY AND/OR UNEXPECTED OPERATION
Configuration screens contain settings that should only be adjusted by a
qualified installer aware of the effects that the changes will have. Incorrect
settings could lead to increased shock or fire hazard, and risk of damage to
the inverter, batteries, or other equipment.
The wizard will reconfigure all of the devices on the connected Xanbus
network. If this is not what you want to do then do not proceed with the wizard.
Failure to follow these instructions can result in death or serious injury,
and/or equipment damage.
Figure 2-2 Warning Screen