Conext Configuration Tool Manual

System Configuration
2–4 975-0720-01-01
This manual is for use by qualified personnel only
Quick Configuration Method
1. Reset devices to factory defaults:
After selecting the Quick configuration method, the Factory Defaults screen
appears. When using the Configuration Wizard, it is recommended to set all
devices to Factory Defaults. If there are customized settings you want to
preserve, devices must be configured separately. See Chapter 3, “Device
Configuration”.
If you click the Reset all devices to factory defaults checkbox, then click
Next, the system resets. This process takes about 20 seconds. During this
time, the pointer changes to an hourglass and the Next button is unavailable.
When the appearance of the pointer returns to normal and the Next button is
available again, the reset has completed.
2. Set the Device Numbers for all devices:
The network requires that each device of the same type (for example, two
inverter/chargers) have a unique number.
When only one device of a certain type is on the network, Conext
Configuration Tool automatically assigns 01 as the device number.
When several devices of a certain type are on the network, you must
manually set device numbers.
To set device numbers:
a) On the left side of the screen, right-click the device icon. When selected,
the icon is highlighted green.
To confirm selection, the device identifies itself on its front panel.
• Conext XW+ Inverter/Chargers flash all LEDs
• Conext MPPT 80 600/ MPPT 60 150 Solar Charge Controllers flash the
LCD
• Automatic Generator Starts flash all LEDs
• System Control Panels beep.
Figure 2-3 Device Number (One Device Selected)