Conext Configuration Tool Manual

System Configuration
2–6 975-0720-01-01
This manual is for use by qualified personnel only
Setting the connections for a Xanbus-enabled device provides a way of
identifying connections for Xanbus-enabled devices and enhancing
networked power system management. When connections are set, devices
of different types can detect that they share, for example, a common DC
input source, or a common grid or generator source.
4. Configure phase operation for inverter/chargers.
Depending on your inverter/charger model, the Conext Configuration Tool
displays windows for single-phase, split-phase or three-phase configuration. See
Figure 2-6.
Configuring Single Phase or Three-Phase Master and Slave Devices
If you are configuring single phase units, the next window to appear will be “Set
number of phases for Conext XW Inverter/Charger”. Single phase units can be
wired in either a single-phase configuration or a three-phase configuration.
To begin configuring single-phase units, select the number of phases and click
Next.
Single-Phase Configuration
Figure 2-5 System Connection Associations
Figure 2-6 Selecting the Number of Phases
If you selected Single Phase,
follow the instructions for
“Configuring Single Phase or
Three-Phase Master and Slave
Devices” on page 2–6.
If you selected Three Phase,
follow the instructions for
“Three-Phase Configuration” on
page 2–9.
If you selected Split Phase,
follow the instructions for
“Configuring Split Phase
Master and Slave Devices” on
page 2–8.