Conext Configuration Tool Manual

Using the Configuration Wizard
975-0720-01-01 2–7
This manual is for use by qualified personnel only
To configure a single-phase unit in a single-phase configuration:
a) In the Single Phase Unit Assignment window, drag and drop the unit that
you want to be the system master into the empty master box. Only one
device can be assigned to be the master.
b) Drag and drop the remaining devices into the slave box. When dragging
and dropping a unit the display on the front panel will flash to indicate
what device has been selected. The Next button is not active unless all
devices have been assigned as either a master or a slave.
c) Click Next when selection is finished. Proceed to Set the Inverter/
Charger settings on page 2–10.
Figure 2-7 Single-Phase Unit Assignment Window
Figure 2-8 Completing Single Phase Unit Assignment