Conext Configuration Tool Manual

975-0720-01-01 iii
This manual is for use by qualified personnel only
About This Guide
Purpose
The purpose of this Owner’s Guide is to provide explanations and procedures for
installing and operating the Schneider Electric Conext Configuration Tool.
Scope
The Guide provides safety guidelines, detailed planning and setup information,
procedures for installing the software, as well as information about operating and
troubleshooting the unit. This Guide does not provide details about particular
brands of batteries, photoelectric cells, or generators. Consult individual battery
manufacturers for this information.
Audience
The Guide is intended for any qualified personnel planning to install and operate
Conext Configuration Tool. Certain configuration tasks should only be performed
by qualified personnel in consultation with your local utility and/or an authorized
dealer. Electrical equipment should be installed, operated, serviced, and
maintained only by qualified personnel. Keep unqualified personnel away from
batteries. Servicing of batteries must only be performed or supervised by
qualified personnel with knowledge of batteries and their required
precautions.Qualified personnel have training, knowledge, and experience in:
• Working with distributed power sources
• Installing electrical equipment
• Applying applicable installation codes
• Analyzing and reducing the hazards involved in performing electrical work
• Installing and configuring batteries
• Installing hardware and software on a Windows-based computer
• Selecting and using Personal Protective Equipment (PPE)
No responsibility is assumed by Schneider Electric for any consequences arising
out of the use of this material.
Organization
This Guide is organized into five chapters and one appendix:
Chapter 1, “Introduction and Installation” introduces Conext Configuration Tool
and describes how to install the software and connect Conext Configuration Tool
to the Xanbus network.
Chapter 2 contains information and procedures to configure a Conext XW+
Inverter/Charger system using the Conext Configuration Tool Configuration
Wizards.