Conext Configuration Tool Manual

Using the Configuration Wizard
975-0720-01-01 2–17
This manual is for use by qualified personnel only
The network requires that each device of the same type have a unique
number.
When only one device of a certain type is on the network, Conext
Configuration Tool automatically assigns 01 as its device number.
When several devices of a certain type are on the network, you must
manually set device numbers.
To set Device Numbers:
a) On the left side of the screen, right-click the device icon. When selected,
the icon is highlighted green.
To confirm selection, the device identifies itself on its front panel.
• Conext XW+ Inverter/Chargers flash all LEDs
• Conext MPPT 80 600/ MPPT 60 150 Solar Charge Controllers LCD
flashes
• Automatic Generator Starts flash all LEDs
• System Control Panels beep.
If possible, take note of which units are assigned which device numbers. You
may also want to label each unit with its device number.
b) Drag the device icon to the appropriate numbered space. Drag by right-
clicking and holding down the right mouse button while dragging.
c) After all the devices have a device number assigned, click Next.
Figure 2-17 Device Number (One Device Selected)