Conext Configuration Tool Manual

System Configuration
2–18 975-0720-01-01
This manual is for use by qualified personnel only
3. Set the AC and DC connections for all devices.
Setting the connections for a Xanbus-enabled device provides a way of
identifying connections for Xanbus-enabled devices and enhancing
networked power system management. When connections are set, devices
of different types can detect that they share, for example, a common DC
input source, or a common grid or generator source.
4. Configure phase operation for inverter/chargers.
Depending on your inverter/charger model, the Conext Configuration Tool
displays windows for single-phase, split-phase or three-phase configuration. See
Figure 2-19.
When selection is finished, click Next. Proceed to Set the Inverter/Charger
settings.
Figure 2-18 System Connection Associations
Figure 2-19 Selecting the Number of Phases
If you selected Single Phase,
follow the instructions for
“Configuring Single Phase or
Three-Phase Master and Slave
Devices” on page 2–6.
If you selected Three Phase,
follow the instructions for
“Three-Phase Configuration” on
page 2–9.
If you selected Split Phase,
follow the instructions for
“Configuring Split Phase
Master and Slave Devices” on
page 2–8.