Conext Configuration Tool Manual

System Configuration
2–20 975-0720-01-01
This manual is for use by qualified personnel only
6. Set the XW Inverter/Charger Settings.
Figure 2-21 XW Inverter/Charger Settings
Table 2-6 XW Inverter/Charger Settings
Setting Description
Battery Type Selects the system battery chemistry and type: Flooded (default), AGM, Gel, Custom
and Lithium Ion.
If you select Custom, a screen for configuring voltage settings for each charging
stage is displayed after you click Next.
Battery
Capacity
Selects the system battery capacity in amp-hours.
Charger
Enabled
Enables or disables the charger.
Maximum
Charge Rate
Sets the percentage of the maximum DC output current that is available to the charger.
Refer to the Owner’s Guide for your inverter to determine the maximum DC output
current for different models.
Charge Cycle Sets the charging method: 3Stage (Bulk, Absorption, Float) and 2StageNoFloat (Bulk,
Absorption, NoFloat), and External BMS.
Recharge Volts Sets the battery voltage level at which a new charge cycle begins.
Inverter
Enabled
Enables the inverter when selected.
AC Input
Priority
Sets the priority for the AC source (AC1 or AC2) for qualification and transfer. For
example, this setting allows the inverter/charger to use a renewable energy source
(such as an AC hydro generator) connected to AC2 on a first-priority basis and use
utility power only when renewable energy is insufficient or unavailable to power loads.