Conext Configuration Tool Manual

Using the Configuration Wizard
975-0720-01-01 2–29
This manual is for use by qualified personnel only
you want to be the phase master into the master boxes for each of the
three phases. Only one device can be assigned to be the master for
each phase.
b) Drag and drop the remaining devices into the slave boxes for the three
phases. The devices selected as master and slaves for a phase must be
physically wired to the same phase. When dragging and dropping a unit
the display on the front panel will flash to indicate what device has been
selected. The Next button is not active unless all devices have been
assigned and one device has been selected as a master for each phase.
4. Select the Advanced Features to Enable for your Multi-Cluster configuration.
Figure 2-31 Setting the Three Phase Unit Assignments
Figure 2-32 Selecting Advanced features
Table 2-12 Common Connection Association Settings
Setting Description
Transfer Switch
Location
Specifies the Transfer Switch Location. Select Internal if using the transfer switch
inside the Conext XW+ or External if using a Transfer Switch on the AC Input.