Conext Configuration Tool Manual

Configuring Conext XW/XW+/SW Inverter/Chargers
975-0720-01-01 3–9
This manual is for use by qualified personnel only
Battery Configuration
Battery Configuration gives you options for configuring the battery for your
inverter/charger.
Charger Block
Stop
Conext XW+ only: Sets the time that charging on AC1 can resume. At the Charger
Block Stop time, charging on AC1 is enabled again.
Conext SW only: Sets the time that charging can resume.
Table 3-2 Charger Settings
Setting Description
Figure 3-8 Battery Configuration Menu
Table 3-3 Battery Configuration Menu
Battery Type Selects the system battery chemistry and type: Flooded (default), AGM, Gel and
Custom.
If you select Custom, the Charger Configuration screen for configuring voltage
settings for each charging stage is displayed (see Figure 3-7).
Battery Capacity Selects the system battery capacity in amp-hours.
Equalization
Support
Enables or disables the ability to enter an equalization cycle. Refer to the battery
manufacturer’s specifications to determine whether equalization is recommended.
Equalization
Voltage
Selects the equalization voltage. Consult your battery manufacturer for equalization
voltage setting.
Bulk Voltage Sets the bulk voltage for a custom battery type.