Conext Configuration Tool Manual

Device Configuration
3–18 975-0720-01-01
This manual is for use by qualified personnel only
Setting Description
Device Name Specifies the displayed name of the charge controller. Gives each Xanbus-enabled
device a unique identifiable name. This makes each device easier to identify when
multiple Xanbus-enabled devices are connected together.
Device
Instance
Specifies the number associated with the charge controller, which will appear beside
the Device Name in the application. This provides the means to use the same name,
but different numbers for similar devices (such as XW MPPT80 01 and XW MPPT80
02). If there is more than one charge controller running on the system, this number
must be manually changed and updated for subsequent devices. The device must be
in standby mode to update this setting.
Solar Array
Association
Selects the solar array number associated with the charge controller. It is suggested
but not required to have the Device Instance number correspond with the Solar Array
Association number.
Battery
Association
Tells the charge controller which battery bank to use for the charger based triggers. It
is suggested but not required to have the Device Instance number correspond with
the Battery Association number.
Stacking Conext XW+ only: For a multi-unit system to operate, one inverter/charger must be
configured to “SplitPhMaster” and the rest as “SplitPhSlave,” otherwise a system-wide
fault is asserted.
Conext SW only: For a multi-unit system to operate, one inverter/charger must be
configured to master and the other as slave, otherwise a system-wide fault is
asserted.