Product Manual
Configuring Advanced Settings
975-0638-01-01 Rev E 4–31
When installing a multiple unit system, every setting on the Multi Unit Config
menu (except for Dev Name) must be configured for each of the two Conext SW
units in the system. The settings should be configured in the following order: Dev
Number then Invtr Mode.
AC In setting The Conext SW accepts only a single AC source - either from the grid or from a
generator. In a power system where the Conext SW is solely connected to the
grid and an AGS is neither present nor required, the AC In setting can be either
Gen1 or Grid1. Therefore, the default value of Gen1 need not be changed.
In a situation where the AC source is a generator and the AGS is being used to
start the generator to produce AC power, the AC In setting must be set to Gen1.
Therefore, the default value of Gen1 must remain unchanged.
In a power system where the two AC sources are available but only one AC
source can be used, an external transfer switch becomes necessary. When an
external transfer switch is used and an AGS (with a B+ signal connection) is also
present, change the AC In setting to Grid1.
Setting the Device Name
The Dev Name setting allows you to customize the name of the Conext SW as it is
displayed on other screens and menus.
The available characters are:
• A to Z
• a to z
• 0 to 9
•space
To customize the Conext SW name:
1. On the device setup menu, select Advanced Settings.
If Basic Settings appears instead of Advanced Settings on the Setup
menu, display Advanced Settings by pressing Enter + up arrow + down
arrow simultaneously.
On the Advanced Settings menu, select Multi Unit Config, and then
press Enter.
2. Select Dev Name, and then press Enter.
The last letter of the Conext SW name is highlighted.
3. Begin customizing the device name.
• To change the character, press the up or down arrow button. Holding
down the button causes the characters to scroll more quickly.
• To delete the character, press Exit.
• To add characters, press Enter.
NOTE: Increasing the number of characters in a device name may cause other
text on the same line to run off the edge of the screen. Device names should be
limited to 10 characters or less.
ConextSW-NA-OwnersGuide.book Page 31 Thursday, July 23, 2015 3:26 PM