Product Manual

Configuring Advanced Settings
975-0638-01-01 Rev E 4–33
Restoring Factory Default Settings
The Restore Defaults command returns the Conext SW to factory default
settings. After using the Restore Defaults command, the Conext SW is no
longer configured for the power system.
To restore Conext SW default settings:
1. On the Advanced Setup menu, select Restore Defaults.
Warning W252 appears, asking to confirm the Restore Defaults command.
2. To cancel the command, press Exit. To continue with the Restore Defaults
command, press Enter.
Advanced Features Menu
NOTICE
EQUIPMENT DAMAGE
Do not use the Restore Defaults command while the Conext SW is
operating. De-energize the power system and disconnect the Conext SW AC
input before using the Restore Defaults command. Reconfigure the Conext
SW before reconnecting the AC input and re-energizing the power system.
Failure to follow these instructions can damage the inverter/charger.
IMPORTANT: If a warning is already active in the system, selecting Restore
Defaults brings up the Warning List, with warning W252 at the top. Press Enter to
view W252 and continue with the Restore Defaults process.
IMPORTANT: Restoring to default also means that the AC output frequency will
change back to 60 Hz. See “Advanced Features Menu” on page 4–33 for
information on changing the AC output frequency to 50 Hz.
Figure 4-12 Adv Features Menu Screen
Table 4-19 Adv Features Description and Values
a
Item Description Default Range
EuroFreq
When enabled, sets the AC
output frequency to a constant
50Hz.
Disabled Enabled,
Disabled
CSW4024 00: Adv Fea
EuroFreq
StoreInvState
AcCouple
EnhancedAcSup
PLSDelay
NoLoadVD
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[*Enabled] [Disabled]
[Enabled] [*Disabled]
[Enabled] [*Disabled]
[Enabled] [*Disabled]
CSW4024 00: Adv
Inverter Settings
Charger Settings
AC Settings
AC Support
Multi Unit Config
Restore Defaults
Adv Features
See “To select and change a configurable setting:” on page 4–
6 to change the settings.
ConextSW-NA-OwnersGuide.book Page 33 Thursday, July 23, 2015 3:26 PM