Installation Guide
Installation Planning
975-0639-01-01 Rev D 1–17
This guide for use by qualified personnel only
Installation Tools and Materials
Tools
You will need the following tools to install the Conext SW and the battery
temperature sensor.
❐ Wire stripper
❐ Crimping tools for fastening lugs and terminals on DC cables
❐ Phillips screwdriver: #2
❐ Slot screwdriver (1/4" [6mm] wide blade max.)
❐ Needle-nose pliers
❐ Wrench for DC terminals and Installation bracket: 5/16" and M6
❐ Power drill/driver
Materials
You will need the following materials to complete your installation:
❐ DC Switchgear
❐ Strain-relief clamp(s) for AC cables (not provided): 3/4" and/or 1"
❐ DC battery cables sized according to Table 1-2 on page 1–15
❐ Terminals and/or crimp connectors for DC cables (3/8" [9.5mm] stud size)
❐ AC and DC disconnect switches and overcurrent protective devices and
connectors as required. See page 1–14
❐ AC output and input wire. See “AC Wiring” on page 1–13
❐ If the AC ground wire is stranded, each ground wire requires a ring terminal
❐ Four M6 nuts to secure the unit to the installation bracket (supplied)
❐ Four #12 (or equivalent) screws or bolts to mount the installation bracket to
the wall
❐ Four #10 (or equivalent) screws for securing the DC Switchgear to the
installation bracket