Manual

Viewing the Basic and Advanced Settings Menus

975-0638-01-01 Rev E 4–5

Advanced Settings

The Advanced Settings option gives you access to the full range of Conext SW

settings, including everything displayed on the Basic menu. As a safeguard

against unintended Advanced configuration, the SCP displays the Basic settings

by default. To view the Advanced settings, you must perform a special keypress.

To select the Advanced Settings menu:

1. On the Select Device menu, select a Conext SW device.

2. Press Enter. The Setup menu screen appears.

3. Press Enter + up arrow + down arrow at the same time.

The Conext SW Advanced settings include menus for configuring:

• Inverter settings (see page 4–9).

• Charger settings (see page 4–13).

• AC transfer limit settings (see page 4–22.

• AC support settings (see page 4–24).

• Multiple unit operation, including customizing the default model name of the

inverter/charger and setting its network device number. Setting the device

number is important when multiple Conext SW units are on the Xanbus

network and sharing connections such as AC loads and AC generator. The

device number is also used when configuring paralleled Conext SW units for

master-slave operation (see page 4–29).

NOTICE

EQUIPMENT DAMAGE

The advanced settings are intended for qualified installation/service personnel

only. Before changing advanced settings, you must be familiar with the

settings and the system-wide impact of changing those settings. Setting

parameters incorrectly could damage connected equipment (such as

batteries) or could severely affect the performance of your system. Incorrect

charging configuration can lead to battery damage.

Failure to follow these instructions can result in equipment damage.

NOTES:

• This keypress (Enter + up arrow + down arrow) enables the Advanced

settings for every device in the system.

• After performing the keypress, “Advanced Settings” appears at the top of

the Setup menu (see Figure 4-2). When the keypress is performed again, the

Setup menu displays “Basic Settings” as the last item on the menu (see

Figure 4-1).