Product Manual

Configuring Advanced Settings
975-0636-01-01 Rev E 4–31
To customize the Conext SW name:
1. On the device setup menu, select Advanced Settings.
If Basic Settings appears instead of Advanced Settings on the Setup
menu, display Advanced Settings by pressing Enter + up arrow + down
arrow simultaneously.
On the Advanced Settings menu, select Multi Unit Config, and then
press Enter.
2. Select Dev Name, and then press Enter.
The last letter of the Conext SW name is highlighted.
3. Begin customizing the device name.
• To change the character, press the up or down arrow button. Holding
down the button causes the characters to scroll more quickly.
• To delete the character, press Exit.
• To add characters, press Enter.
4. When the correct character is shown, press Enter to select it.
5. After pressing Enter to select the last character of your customized device
name, press Enter again to return to the menu.
Setting the Device Number
Setting the device number gives a Xanbus-enabled device a unique identity
when several devices of the same type are installed in the networked power
system. When each identical device has a unique number, the SCP can correctly
identify and display status information for each device. A device number consists
of two digits ranging from 00 (default) to 31.
If only one of each device is installed in the networked power system, you do not
need to set the device number. However, setting the device number to a value
other than 00 is recommended in case you need to use the Restore Defaults
command. After performing the command, checking that the device number has
returned to 00 indicates that the command was successfully completed.
To set the Conext SW device number:
1. On the Conext SW Setup menu, select Advanced Settings.
If Basic Settings appears instead of Advanced Settings on the Setup
menu, display Advanced Settings by pressing Enter + up arrow + down
arrow simultaneously.
On the Advanced Settings menu, select Multi Unit Config, and then
press Enter.
2. On the Multi Unit Config menu, select Dev Number. See Figure 4-11.
3. Press Enter to highlight the instance number.
4. Use the up and down arrow buttons to adjust the two-digit identifier number.
5. Press Enter.
ConextSWEUROwnersGuide.book Page 31 Thursday, July 23, 2015 3:32 PM