Installation Manual

Introduction
1–6 975-0239-01-01 Rev J
This manual is for use by qualified personnel only
The Conext XW+ Power Distribution Panel includes the components shown
below
.
Not shown:
• One ground terminal bus bar
• One neutral terminal bus bar
• One battery negative terminal bus bar
• Zap-strap cable ties (3x)
Figure 1-4 Conext XW+ Power Distribution Panel with Conduit Box
XW+ Conduit Box
#4/0 AWG Arctic Ultraflex Blue™
battery cables
GJ250A 160 VDC,
3/8" stud DC breaker
Two-tab power
#6 AWG AC wiring
(includes 4 conduit bushings)
Three 60 A, 120/240 VAC,
AC breakers for AC input,
Type QOU, DIN-rail mounted
Bypass, and AC Load
two-pole, Square-D,
distribution jumpers
(pre-installed)
(pre-installed)
(pre-installed)
(pre-installed)
Conext XW+ PDP
XW-NA-Install.book Page 6 Wednesday, August 12, 2015 2:23 PM