Product Manual

Monitoring Operation
2–12 975-0240-01-01
System Status Screen The System Status screen appears after the startup
screen. It displays aggregated status information for the entire power system.
For example, a system might have three Xanbus network-connected Conext
XW+ Inverter/Chargers, two Conext Solar Charge Controllers, one Conext AGS
module, and one Conext SCP connected to a single battery bank, a single
generator, and a common utility grid.
The System Status screen features a Menu arrow pointing to the Enter button.
Pressing Enter takes you to the Select Device menu. For more information, see
“Reading the System Status Screen” on page 2–13.
Conext XW+ Home Screen The Conext XW+ Home screen is the first of the
device Home screens. Each Conext XW+ installed in the system has its own
Home screen.
Figure 2-4 Conext System Control Panel Top Level Screens
System Status Select Device
XW+ 6848:Home
Device 2:Home
Device 3:Home
Device 4:Home
Appears for a few seconds after the system starts
up or when the system has been reset.
Press Enter to view
Select Device menu.
Select device from list
and press Enter to view
Device Setup menu.
Press Enter from a Device Home screen
to view the Device Setup menu.
The number of Home screens depends
on the number of Xanbus-enabled
devices installed in the system.
Startup Screen
System Status
Screen
Conext XW
Home Screen
Device 2
Home Screen
Device 3
Home Screen
Device 4
Home Screen
Select Device
Screen
Note: If you are uncertain as to which Conext SCP screen or menu you are
viewing, you can return to the starting point—the System Status screen—by
pressing Exit repeatedly until the screens stop changing.
XW_Operation.book Page 12 Wednesday, August 12, 2015 2:39 PM