Product Manual

Using the Setup Menus
975-0240-01-01 3–5
The Conext XW+ advanced settings include menus for configuring:
• Inverter settings (see page 3–8)
• Charger settings (see page 3–11)
• AC transfer limit settings (see page 3–23)
• Grid support and peak load shaving settings (see page 3–25)
• Generator support settings (see page 3–34)
• Auxiliary output settings (see page 3–36).
• Multi-unit operation, including customizing the default model name of the
Conext XW+ and setting its network device number. Setting the device
number is important when multiple Conext XW+ units are on the Xanbus
network and sharing connections such as AC loads, utility grid, and
generator. The device number is also used when configuring paralleled
Conext XW+ units for master-slave operation (see “Inverter Settings Menu”
on page 3–8).
In the advanced settings you can also copy another unit’s settings using the Copy
from command.
To view the advanced or basic settings:
•From the Setup menu, with Basic Settings or Advanced Settings
highlighted, press Enter. See Figure 3-2.
To select and change a configurable setting:
1. On the desired configuration menu, press the up arrow or down arrow button
to highlight the setting you want to change.
2. Press Enter to highlight the current value of the setting.
3. Press the up arrow or the down arrow button to change the value. Hold down
the button to scroll through a large range of values quickly.
The previously set value appears with an asterisk (*) beside it.
4. Press Enter to select the value.
Figure 3-2 Selecting Advanced Settings
XW+ 6848 00: Adv
Inverter Settings
[XW+ 6848 01]
XW+ 6848 00: Setup
Advanced Settings
[Enabled]
[Disabled]
[Disabled]
[Enabled]
[None]
[Disabled]
[Operating]
XW_Operation.book Page 5 Wednesday, August 12, 2015 2:39 PM