Product Manual

Multi-Unit Config Menu

975-0240-01-01 3–39

Multi-Unit Config Menu

The Multi-Unit Config menu configures the Conext XW+ to operate as a part of

a multi-unit installation.

When installing a multi-unit system, each setting on the

Multi-Unit Config

(except for

Dev Name

) must be configured for each Conext XW+ in the system. The

settings should be configured in the following order:

•Dev Number

• Inverter Mode

• Connections

WARNING

ADVANCED CONFIGURATION HAZARD

Advanced menu settings should be used by qualified personnel only.

Three phase operation should be configured by qualified personnel only.

Consult with the local utility before enabling Conext XW+ sell mode or grid

support functions.

Do not change these settings unless you are under the supervision and

direction of qualified personnel.

Failure to follow these instructions can result in death or serious injury.

Note: Accessing this menu automatically places the Conext XW+ in standby

mode and de-energizes the circuits on inverter output. When entering the Multi-

Unit Config menu, the unit identifies itself by flashing the front panel lights. After

exiting the Multi-Unit Config menu, the Conext XW+ returns to operating mode

and the front panel lights stop flashing.

Table 3-9 Multi-Unit Config Menu

Item Description Default Range

Dev Name Allows customization of the default device name.

This setting is optional and does not affect operation.

See “Setting the Device Name” on page 3–41.

n/a n/a

Dev Number Allows setting of a unique unit number in a multiple-unit

system. See “Setting the Device Number” on page 3–42.

00 00–31

XW_Operation.book Page 39 Wednesday, August 12, 2015 2:39 PM