Installation Guide

PAGE 1

Apron Front Stainless Steel Sink

Installation Instructions

FOR MODELS: SCAPLG16, SCAPL604016, SCAPS16, SCAPS604016, SCAP505016

o Tape Measure

o Safety Glasses

o Painter’s Tape

o Saw

o Level

o Framing Square

o Pencil (not permanent marker)

o Shims or Cabinet Fillers

o Denatured Alcohol

o Clamps

o Construction Adhesive

o Silicone Sealant

o Support Framing Material (1 ¼” (32mm) Max Thickness)

o Screws (recommended by countertop manufacturer)

Recommended Tools & Materials (Not Included)

• Schön recommends that all apron front sinks should be installed by an experienced, professional installer.

• IMPORTANT: The enclosed cutout template will create a countertop opening with a minimal (1/8” or less) reveal. It is

recommended that you discuss this with your installer and agree that this nished appearance is the desired eect. Schön is not

responsible for improper sink or countertop installations.

• IMPORTANT: The cabinet must be installed, secured, plumb, and level. The front sink apron must be secured to the front of the

cabinet by attaching fasteners through the cabinet front and into the support framing. Failure of this step can lead to product

damage.

• IMPORTANT: Long screws may damage adjacent cabinets. Ensure the screws are long enough to secure the support framing, but

short enough not to go through the walls of adjacent cabinets.

• Schön apron front sinks should only be fastened to a solid surface countertop (i.e. granite, Corian® or Silestone®).

• A custom sink base cabinet and support framing is required for proper installation. Schön recommends providing the cabinet

maker with the actual sink to be installed prior to cabinet fabrication.

• Schön is not responsible for sink or countertop if damaged during installation. Be sure to inspect the sink for damage prior to

beginning installation.

• Metal edges may be sharp – use caution when handling.

• Follow all local plumbing and building codes.

Before You Start

SCAPL604016 SCAPLG16

PAGE 1
Apron Front Stainless Steel Sink Installation Instructions FOR MODELS: SCAPLG16, SCAPL604016, SCAPS16, SCAPS604016, SCAP505016 SCAPL604016 SCAPLG16 Before You Start • Schön recommends that all apron front sinks should be installed by an experienced, professional installer. • IMPORTANT: The enclosed cutout template will create a countertop opening with a minimal (1/8” or less) reveal.
PAGE 2
Apron Front Stainless Steel Sink Installation Instructions 1: Prepare the base cabinet Outline for Apron Front Sink Cutout 1. Apply painter’s tape to the cabinets for marking and cutting purposes. This will protect the cabinet from damage while cutting. 2. Position the template (provided with your sink) on the front of the cabinet, flush to the top and centered; secure with tape. 3. Trace the template and remove. 4. Using a sharp saw blade, carefully cut the cabinet on the traced line.
PAGE 3
Apron Front Stainless Steel Sink Installation Instructions 1. Lower the sink onto the supports and verify the sink is supported by the frame. 2. Push the sink in to ensure the apron is flush to the front of the cabinet. 4: install the sink 3. Verify the sink is level. Make any adjustments and shim as needed. 4.