Parts Sheet

5890-__ __M PAGE 4
5890-__ __M PAGE 5
4
You will need 3 - G16-1/2
25 Watts Recommended
40 Watts Max
MIN 90°C SUPPLY
CONDUCTORS
Install bulbs and be sure
to test fixture BEFORE
trimming.
7
B
E
Crystal Chain
has a small jewel
at bottom.
8
ILLUSTRATION 3
ILLUSTRATION 1
ILLUSTRATION 2
5 Assemble all crystal chains and pins provided.
See "Crystal Chain Assembly" above. Set mirror
plate on cardboard stand. Hook all Crystal Chains
"E" into slots in the mirror plate so the metal acces-
sories face outwards and the square jewel is on the
upper end. See illustrations #1 - #3. NOTE: Allow
ends with small jewels to hang loose.
6 Align holes in mirror plate with the balls on the
frame, raise mirror plate over balls, then turn mirror
clockwise until holes are halfway between balls. See
illustration #4.
NOTE: There will be a slight resistance
when putting the pin through the top crystal.
Do NOT bend pin or try to scrape out
crystal hole. The resistance holds the
crystal chain on the pin.
CRYSTAL CHAIN ASSEMBLY
MOUNTING
POINTS
LIGHT
CLUSTER
ILLUSTRATION 4
MIRROR
PLATE