Installation and Assembly

ManualsBrandsSchonbek ManualsFlush MountsPetit 36 - Light 48" Unique/Statement Tiered Flush Mount

This fixture was designed and manufactured in Plattsburgh, N.Y. Our high-quality crystal

fixtures are made with state-of-the-art manufacturing equipment. If you have any questions

about this or any of our more than 450 crystal products, contact your nearest authorized

Schonbek distributor.

CAUTION... RISK OF ELECTRICAL SHOCK. Make sure the electrical supply to the

chandelier is turned off at the main fuse or circuit breaker before doing any installation. All

electrical components must be installed by a licensed electrician in accordance with the Na-

tional Electric Code and the appropriate local electrical codes.

HANGING WEIGHT: 190 pounds.

BULBS: (36) Round shaped candelabra base G16-1/2 bulbs, recommend 25 watts

for best appearance.

25 - Watts Maximum

MIN 75°C SUPPLY CONDUCTORS

WARNING: This chandelier meets UL/CSA requirements. Any tampering will void

UL/CSA certification.

IMPORTANT

Please record the following information for future service.

CODE # ________ Four-digit number on outside of carton.

PACKER # ________ See crystal package label.

ORDER # ________ See crystal package label.

CHANDELIER 5897- __ __M TRIM DIAGRAM

HIS DESIGN IS THE PROPRIETARY

TRADE DRESS/TRADEMARK OF

SCHONBEK WORLDWIDE LIGHTING

INC.

36 Lights

Diameter: 48"

Body Length: 21"

(Finish Option)

Summary of content (4 pages)

PAGE 1
CHANDELIER 5897- __ __M TRIM DIAGRAM (Finish Option) T HIS DESIGN IS THE PROPRIETARY TRADE DRESS/TRADEMARK OF SCHONBEK WORLDWIDE LIGHTING INC. 36 Lights Diameter: 48" Body Length: 21" This fixture was designed and manufactured in Plattsburgh, N.Y. Our high-quality crystal fixtures are made with state-of-the-art manufacturing equipment. If you have any questions about this or any of our more than 450 crystal products, contact your nearest authorized Schonbek distributor. CAUTION...
PAGE 2
WASHER UPPER FRAME WARNING: THIS LUMINAIRE MUST BE MOUNTED OR SUPPORTED INDEPENDENTLY OF AN OUTLET BOX. NOTES: RUNNING THREAD LARGE HEX NUT LOWER FRAME NUT SEATING RING DECORATIVE BALL JACKCHAIN FINIAL 1 MAKE SURE POWER IS DISCONNECTED!! 2 Attach washer to supporting member in ceiling sufficient to support weight of fixture. 3 Install upper frame assembly up over running thread to fit tight against the washer and secure with large hex nut. 4 Again, make sure that power is disconnected.
PAGE 3
ILLUSTRATION 1 13 Reminder: Hang upper gallery Chains "A" FIRST! Hook all Crystal Chains "F" into slots in the mirror plate so the metal accessories face outwards and the square jewel is on the upper end. See illustrations #1 - #3. NOTE: Allow ends with small jewels to hang loose. 8 Perspiration or oil from fingers will ILLUSTRATION 2 smear the crystals, causing a loss of brilliance. ALWAYS USE FINGER COTS PROVIDED WHEN HANDLING CRYSTALS.
PAGE 4
A Crystal Chain has a small jewel at bottom. E Crystal Chain has a small jewel at bottom. F PERMANENT MOUNTING Crystal Chain has a small jewel at bottom. TEMPORARY MOUNTING D 9 Hang upper mirror Chains "A" FIRST. Hook all Chains "A" into holes in the outer ring so that the metal accessories face outwards and square jewel is on the upper end. Hook the loose end of Crystal Chains "A" with small jewels into holes of solid mounted metal ring.