Jump Starter/DC Power Source Owner's Manual

9
DIGITAL DISPLAY FUNCTIONS
1. PP-18400CI To check the internal
battery’s status, press the DISPLAY
button on the front of the PP-18400CI.
The display will show the voltage of
the internal battery.
2. When hooked up to the vehicle's
battery, the digital display shows the
combined vehicle's voltage and the
PP-18400CI's internal battery volt-
age.
3. AC Power When using the PP-
18400CI inverter, the digital display
shows the wattage and voltage of
the device being powered. Push the
DISPLAY button to read wattage
or push DISPLAY button again to
read voltage. The internal battery is
specically designed to deliver high
power jump-starting as well as repeti-
tive deep cycling performance.
CHARGING INTERNAL BATTERY
NOTE: Internal battery’s status DISPLAY
is most accurate when the Portable Power
PP-18400CI has been disconnected from
all devices and charging sources for at
least 30 minutes. The DISPLAY feature
will not work when the Portable Power is
being charged.
CAUTION: Operating the Portable Power
PP-18400CI while the internal battery is
being charged may cause permanent
damage to the PP-18400CI.
1. To check the internal batterys charge
level, press the DISPLAY button. The
Digital Display will show the batterys
voltage.
2. To charge, follow instr uc ti ons
CHARGE INTERNAL BATTERY on
page 4.
3. Once the battery is fully charged,
the built-in charger automatically
switches to oat-mode monitoring,
which trickle charges the battery
and keeps it fully charged without
overcharging so the PP-18400CI may
be left permanently connected to the
electrical wall outlet.

ING CORD
The internal battery may also be charged
while you drive by using the male-to-male
accessory cable (included).
1. Make sure the PP-18400CI is OFF.
2. Insert one end of the male charging
cord into the PP-18400CI’s 12V DC
power outlet and the other end into
the vehicle’s accessory outlet (lighter
socket). Important: Disconnect
power cord from the PP-18400CI and
the vehicle’s accessory outlet when
engine is not running.