OWNER’S MANUAL MANUAL DEL USUARIO Model / Modelo: SC-300A Automatic Battery Charger Cargador de batería automático Voltage / Tensión: 12 Amperage / Amperaje: 3 DO NOT RETURN THIS PRODUCT TO THE STORE! Call Customer Service for assistance: 800-621-5485 ¡NO LO DEVUELVA ESTE PRODUCTO A LA TIENDA! Llame a Servicios al Cliente para asistencia: 800-621-5485 READ THE ENTIRE MANUAL BEFORE USING THIS PRODUCT. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY OR DEATH.
IMPORTANT: READ AND SAVE THIS SAFETY AND INSTRUCTION MANUAL. SAVE THESE INSTRUCTIONS – This manual will show you how to use your charger safely and effectively. Please read, understand and follow these instructions and precautions carefully, as this manual contains important safety and operating instructions. The safety messages used throughout this manual contain a signal word, a message and an icon. The signal word indicates the level of the hazard in a situation.
1.4 To reduce the risk of damage to the electric plug or cord, pull by the plug rather than the cord when disconnecting the charger. 1.5 An extension cord should not be used unless absolutely necessary. Use of an improper extension cord could result in a risk of fire and electric shock. If an extension cord must be used, make sure: • That the pins on the plug of the extension cord are the same number, size and shape as those of the plug on the charger.
1.12 This charger employs parts, such as switches and circuit breakers, that tend to produce arcs and sparks. If used in a garage, locate this charger 18 inches (46 cm) or more above floor level. 2. PERSONAL PRECAUTIONS RISK OF EXPLOSIVE GASES. 2.1 NEVER smoke or allow a spark or flame in the vicinity of a battery or engine. 2.2 Remove personal metal items such as rings, bracelets, necklaces and watches when working with a lead-acid battery.
3. PREPARING TO CHARGE RISK OF CONTACT WITH BATTERY ACID. BATTERY ACID IS A HIGHLY CORROSIVE SULFURIC ACID. 3.1 If it is necessary to remove the battery from the vehicle to charge it, always remove the grounded terminal first. Make sure all of the accessories in the vehicle are off to prevent arcing. 3.2 Be sure the area around the battery is well ventilated while the battery is being charged. 3.3 Clean the battery terminals before charging the battery.
4.2 Never place the charger directly above the battery being charged; gases from the battery will corrode and damage the charger. 4.3 Do not set the battery on top of the charger. 4.4 Never allow battery acid to drip onto the charger when reading the electrolyte specific gravity or filling the battery. 4.5 Do not operate the charger in a closed-in area or restrict the ventilation in any way. 5. DC CONNECTION PRECAUTIONS 5.
6.5 For a negative-grounded vehicle, connect the POSITIVE (RED) clip from the battery charger to the POSITIVE (POS, P, +) ungrounded post of the battery. Connect the NEGATIVE (BLACK) clip to the vehicle chassis or engine block away from the battery. Do not connect the clip to the carburetor, fuel lines or sheet-metal body parts. Connect to a heavy gauge metal part of the frame or engine block. 6.
7.6 Connect charger AC supply cord to electrical outlet. 7.7 When disconnecting the charger, always do so in the reverse order of the connecting procedure and break the first connection while as far away from the battery as practical. 7.8 A marine (boat) battery must be removed and charged on shore. To charge it onboard requires equipment specially designed for marine use. 8. AC POWER CORD CONNECTIONS RISK OF ELECTRIC SHOCK OR FIRE. 8.1 This battery charger is for use on a nominal 120-volt circuit.
10. ASSEMBLY INSTRUCTIONS Remove all cord wraps and uncoil the cables prior to using the battery charger. 11. CONTROL PANEL LED Display CHECK BATTERY (red) LED lit: Indicates that the battery is not properly connected to the charger or the battery is bad. CHARGING (yellow) LED lit: Indicates the charger is charging the battery. CHARGED (green) LED lit: Indicates the battery is fully charged and the charger is in maintain mode. 12.
NOTE: Never connect the output cable assemblies together for use in other applications, such as external battery or other power source charging, or to extend the output cable length, as reverse polarity and/or overcharge conditions will occur. Completed Charge When the CHARGED LED is lit and the CHARGING LED turns off, the battery is completely charged and the charger has stopped charging and switched to the Maintain Mode of operation.
14. TROUBLESHOOTING PROBLEM Power light will not turn on. Charger makes a loud buzz. POSSIBLE CAUSE REASON/ SOLUTION AC outlet is dead. Check for an open fuse or circuit breaker supplying the AC outlet. Poor electrical connection. Check the power cord and extension cord for a loose fitting plug. Transformer laminations vibrate. No problem; this is a normal condition. 15. BEFORE RETURNING FOR REPAIRS 15.
17. LIMITED WARRANTY WARRANTY NOT VALID IN MEXICO. SCHUMACHER ELECTRIC CORPORATION, 801 BUSINESS CENTER DRIVE, MOUNT PROSPECT, IL 60056-2179, MAKES THIS LIMITED WARRANTY TO THE ORIGINAL RETAIL PURCHASER OF THIS PRODUCT. THIS LIMITED WARRANTY IS NOT TRANSFERABLE OR ASSIGNABLE. Schumacher Electric Corporation (the “Manufacturer”) warrants this battery charger for 2 years from the date of purchase at retail against defective material or workmanship that may occur under normal use and care.
Some states do not allow the exclusion or limitation of incidental or consequential damages or length of implied warranty, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights and it is possible you may have other rights which vary from this warranty. THIS LIMITED WARRANTY IS THE ONLY EXPRESS LIMITED WARRANTY AND THE MANUFACTURER NEITHER ASSUMES OR AUTHORIZES ANYONE TO ASSUME OR MAKE ANY OTHER OBLIGATION TOWARDS THE PRODUCT OTHER THAN THIS WARRANTY.
• 14 •
• 15 • DESCRIPTION:___________________________ Schumacher Electric Corporation 801 Business Center Drive Mount Prospect, IL 60056-2179 Do not send unit to this address for repair.
• 16 • Schumacher Electric Corporation 801 Business Center Drive Mount Prospect, IL 60056-2179 Código de barras ________________________(CONSULTE EL PRODUCTO) Localización de la Tienda___________________Numero de Serie _______________ Nombre de la Tienda donde se Compró_________________Fecha de compra _____ Tel:_______________________Correo electrónico____________________________ Ciudad_______________________________Estado_____________C.P.
IMPORTANTE: LEA Y GUARDE ESTE MANUAL DE INSTRUCCIONES Y SEGURIDAD. GUARDE ESTAS INSTRUCCIONES – Este manual le mostrará cómo utilizar su cargador en forma segura y efectiva. Por favor, lea, comprenda y siga estas instrucciones y precauciones cuidadosamente, ya que este manual contiene instrucciones operativas y de seguridad de importancia. Los mensajes de seguridad representados en este manual contienen palabras guía, un mensaje y una figura.
1.3 Utilice solamente accesorios recomendados. El uso de un accesorio no recomendado o suministrado por Schumacher Electric Corporation® puede provocar riesgo de incendio, descarga eléctrica o lesiones a personas o daño a la propiedad. 1.4 Para reducir el riesgo de daños al enchufe o cable eléctrico, jale del enchufe en lugar de jalar del cable al desconectar el cargador. 1.5 No se debe utilizar un alargador a menos que resulte absolutamente necesario.
RIESGO DE GASES EXPLOSIVOS. 1.10 RESULTA PELIGROSO TRABAJAR EN FORMA CERCANA A UNA BATERÍA DE PLOMO. LAS BATERÍAS GENERAN GASES EXPLOSIVOS DURANTE SU NORMAL FUNCIONAMIENTO. POR ESTE MOTIVO, RESULTA DE SUMA IMPORTANCIA QUE SIGA LAS INSTRUCCIONES CADA VEZ QUE UTILIZA EL CARGADOR. 1.11 Para reducir el riesgo de explosión de una batería, siga estas instrucciones y aquellas publicadas por el fabricante de la batería y por el fabricante de cualquier equipo que intente utilizar en la proximidad de la batería.
2.5 NUNCA cargue una batería congelada. 2.6 Considere la idea de que alguna persona se encuentre cerca suyo para poder ayudarlo cuando trabaje en forma cercana a una batería de plomo-ácido. 2.7 Cuente con una gran cantidad de agua potable y jabón a mano en caso de que el ácido de la batería tenga contacto con su piel, ropa u ojos. 2.8 Utilice protección visual y corporal completa, incluyendo gafas de seguridad y prendas de protección. Evite tocar sus ojos mientras trabaje en forma cercana a la batería. 2.
3.4 Agregue agua destilada a cada pila hasta que el ácido de la batería alcance el nivel especificado por el fabricante de la batería. No provoque derrames. En lo que concierne a baterías que no cuentan con tapas extraíbles para pilas, tales como baterías de plomo-ácido reguladas por válvulas (VRLA, por sus siglas en inglés), siga cuidadosamente las instrucciones de recarga del fabricante. 3.
5. PRECAUCIONES DE CONEXIÓN EN CC 5.1 Conecte y desconecte los ganchos de salida C.C. sólo después de haber establecido todos los interruptores del cargador a la posición de “apagado” (si es aplicable) y de haber desconectado el enchufe de C.A. del tomacorriente eléctrico. Nunca permita que los ganchos tengan contacto entre sí. 5.2 Sujete los ganchos a la batería y al chasis, como se indica en las secciónes 6 y 7. 6. SIGA ESTOS PASOS CUANDO LA BATERÍA ESTÉ COLOCADA EN EL VEHÍCULO.
motor alejado de la batería. No conecte el gancho al carburador, líneas de combustible o cuerpos metálicos. Conecte a una pieza metálica de calibre grueso del marco o del bloque motor. 6.6 En un vehículo con descarga a tierra por borne positivo, conecte el gancho NEGATIVO (NEGRO) del cargador de batería al borne NEGATIVO (NEG, N, -) sin descarga a tierra de la batería. Conecte el gancho POSITIVO (ROJO) al chasis del vehículo o al bloque motor alejado de la batería.
7.5 No se ubique en posición frontal a la batería al realizar la conexión final. 7.6 Conecte el condón de alimentación del cargador de CA al tomacorriente. 7.7 Al desconectar el cargador, siempre hágalo en forma inversa al procedimiento de conexión y realice la primera conexión tan lejos de la batería como sea posible. 7.8 Una batería marina (para barcos) se debe retirar y cargar en tierra. Para realizar una carga a bordo se necesitan equipamientos especialmente diseñados para uso marino. 8.
9. CARACTERÍSTICAS 1 2 3 5 4 1. Cable de Conexión Rápida 2. Cable para ensamble con terminal de anillo 3. Cable para ensamble con enchufe de 12V 4. Luces LED para verificar condición de la Batería 5. Cable para ensamble con pinzas para Batería 10. INSTRUCCIONES DE MONTAJE Desenrede todos los cordones y extienda los cables antes de usar el cargador de baterías. 11.
Carga 1. Desconecte el ensamble de cables de seguridad del vehículo para quitar la batería. Examine la batería para detectar cualquier fisura, grieta o daño cada que cargue la batería. Si se detecta daño alguno en la batería, no la cargue, reemplácela inmediatamente. En caso de que la batería esté demasiado caliente, permita que se enfríe un poco antes de cargar. 2. Seleccione el cable de salida apropiado que concuerde con el cable conector de salida y el conector de la batería del vehículo. 3.
Carga Anulada Si la carga no se puede completar con normalidad, la carga se anulará. Cuando la carga se anula, la salida de carga del cargador se apaga, y la se encenderá la luz LED, VERIFIQUE LA BATERIA. Para recomenzar la carga después de haber sido anulada, desconecte el cargador del tomacorriente de CA, espere unos minutos y vuelva a conectar. 13. INSTRUCCIONES DE MANTENIMIENTO Y ALMACENAJE 13.1 Después de usar y antes de realizar mantenimiento, desenchufe y desconecte el cargador de la batería. 13.
15. ANTES DE DEVOLVER A REPARACIONES 15.1 Cuando surja un problema de carga, asegúrese de que la batería puede recibir una carga normal. Verificar dos veces todas las conexiones, el toma de C.A. para obtener 120-volts completos y la calidad de las conexiones del conectador al sistema de la batería. El conectador debe estar limpio. 15.
17. GARANTÍA LIMITADA GARANTIA LIMITADA NO VALIDA EN MEXICO. SCHUMACHER ELECTRIC CORPORATION, 801 BUSINESS CENTER DRIVE, MOUNT PROSPECT, IL 60056-2179, REALIZA LA PRESENTE GARANTÍA LIMITADA AL COMPRADOR MINORISTA ORIGINAL DE ESTE PRODUCTO. LA PRESENTE GARANTÍA LIMITADA NO PUEDE TRANSFERIRSE NI CEDERSE.
El Fabricante no realiza ninguna otra garantía, incluidas, a título enunciativo, las garantías expresas, implícitas o legales, incluidas, a modo de ejemplo, las garantías implícitas de comerciabilidad o adecuación a un fin específico.
LA PRESENTE GARANTÍA LIMITADA ES LA ÚNICA GARANTÍA LIMITADA EXPRESA Y EL FABRICANTE NO ASUME NI AUTORIZA A NADIE A ASUMIR O A ADQUIRIR NINGUNA OTRA OBLIGACIÓN RESPECTO DEL PRODUCTO QUE NO SEA LA PRESENTE GARANTÍA. Servicio de atención al cliente de Schumacher Electric Corporation 1-800-621-5485 Lunes-viernes 7:00 a.m. a 5.00 p.m. CST Schumacher® y el logo Schumacher® son marcas registradas de Schumacher Electric Corporation.