OPERATOR’S MANUAL ® Jump Starter/DC Power Source Model No. 200.71990 CAUTION: Read all Safety Rules and Operating Instructions, and follow them with each use of this product. Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
Table of Contents section page IMPORTANT SAFETY INSTRUCTIONS 1 jump starter/dc power source features 2 Jump-starting a vehicle 2 digital display 3 CHARGING of internal battery with built-in, 3-amp charger.
IMPORTANT: CHARGE IMMEDIATELY AFTER PURCHASE important: read and save this safety and instruction manual. 1. IMPORTANT SAFETY INSTRUCTIONS 1.1 Charge the internal battery immediately upon purchase, every 30 days and after every use. 1.2 Use in a well ventilated space. 1.3 Contains a sealed, non-spillable lead-acid battery. Must be disposed of properly. 1.4 Someone should be within range of your voice or close enough to come to your aid when you are working near a lead-acid battery. 1.
2. jump starter/dc power source features 2 3 1 4 1. 12V DC Power Outlet 2. ON/OFF Power Switch 7 3. Digital Display 4. Display Select Push Button Switch 5 6. Rubber Base 7. Internal Battery Charger Outlet (not shown) 6 3. 5. Replaceable Jaw Battery Clamps Jump-starting a vehicle Warning: Failure to follow instructions may cause damage or an explosion. Read the entire instruction manual before use. 3.1 Turn the ignition off before making cable connections. 3.2 Use in a well-ventilated area.
3.10 If no audio alarm sounds, turn the rotary switch to the 12V position. The clamps are now powered. Crank the engine. If the engine does not start within 5 – 8 seconds, stop cranking and wait at least 1 minute before attempting to start the vehicle again. (This permits the battery to cool down.) 3.11 After the engine starts, turn the rotary switch to the O (OFF) position. Then disconnect the black clamp (-) and then the red clamp (+) in that order.
5.2 Plug at least an 18 gauge (AWG) extension cord into the charger plug on the left side of the jump starter. (Extension cord not included; must be purchased separately.) 5.3 Plug the extension cord into a 120V AC electrical wall outlet. CAUTION: Operating the Jump Starter while the internal battery is being charged may cause permanent damage to the unit. 5.4 Charging of the internal battery could take up to 48 hours due to the age and condition of the battery.
6.2 12V DC Electrical Device Example Run-Time Chart Appliance Type Estimated Power Estimated Time* Fluorescent Lights, Cellular Phones 4 Watts 50 Hours Radios, Depth Finders, Fans 9 Watts 25 Hours Camcorders, DVD Players, Spotlights 15 Watts 13 Hours Electrical Tools, Bilge Pumps 24 Watts 7.3 Hours Electric Coolers 48 Watts 4.5 Hours Air Compressors, Car Vacuums 80 Watts 2 Hour *NOTE: Estimated run-times. Actual time may vary.
9. storage and maintenance important: • charge immediately after purchase • keep fully charged. Charge the internal battery immediately upon purchase, every 30 days and after every use. All batteries are affected by temperature. The ideal storage temperature is between 40 and 70 degrees Fahrenheit. The internal battery will gradually self-discharge (lose power) over time, especially in warm environments. Leaving the battery in a discharged state may result in permanent battery damage.
