Digital Battery Load Owner's Manual

ManualsBrandsSchumacher ManualsPower SupplyPST-200

OWNER’S MANUAL

Model: PST-200

100 Amp Digital Battery Load

Tester/Charging System Analyzer

For 12 Volt Batteries

00-99-000438/1004

Questions? Call Customer Service

1-800-621-5485

Send Warranty Product Repairs To:

Customer Returns

P.O. Box 280

1025 E. Thompson Avenue

Hoopeston, IL 60942-0280

ELECTRIC CORPORATION

MT. PROSPECT, IL 60056

Summary of content (4 pages)

PAGE 1
OWNER’S MANUAL Model: PST-200 100 Amp Digital Battery Load Tester/Charging System Analyzer For 12 Volt Batteries ELECTRIC CORPORATION MT. PROSPECT, IL 60056 Send Warranty Product Repairs To: Customer Returns P.O. Box 280 1025 E.
PAGE 2
INSTRUCTIONS FOR USE WARNING: Handling the cord on this product or cords associated with accessories sold with this product, will expose you to lead, a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling. WARNING - RISK OF EXPLOSIVE GASES 1. Working in the vicinity of a lead acid battery is dangerous. Batteries generate explosive gases during normal battery operation.
PAGE 3
If the tester indicates poor battery condition, allow the battery to stabilize for a few minutes and check the open circuit voltage with voltmeter. This is a good measure of the percent charge in the battery. The battery is considered charged if it measures 75% or more. If it failed the load test with 75% charge or above, it should be replaced. If the battery charge measures less than 75%, it should be charged and load tested again. Replace the battery if it fails again.
PAGE 4
LIMITED WARRANTY SCHUMACHER ELECTRIC CORPORATION, 801 BUSINESS CENTER DRIVE, MOUNT PROSPECT, ILLINOIS 60056-2179 MAKES THIS LIMITED WARRANTY TO THE ORIGINAL PURCHASER AT RETAIL OF THIS PRODUCT. THIS LIMITED WARRANTY IS NOT TRANSFERABLE. Schumacher Electric Corporation warrants this battery tester for six months from date of purchase at retail against defective material or workmanship. If such should occur, the unit will be repaired or replaced at the option of the manufacturer.