Eclipse4 Manual
Table Of Contents
- Eclipse 4 FRONT COVER
- Eclipse 4 PAGE 1
- Eclipse 4 PAGE 2
- Eclipse 4 PAGE 3
- Eclipse 4 PAGE 4
- Eclipse 4 PAGE 5
- Eclipse 4 PAGE 6
- Eclipse 4 PAGE 7
- Eclipse 4 PAGE 8
- Eclipse 4 PAGE 9
- Eclipse 4 PAGE 10
- Eclipse 4 PAGE 11
- Eclipse 4 PAGE 12
- Eclipse 4 PAGE 13 Spares List 1
- Eclipse 4 PAGE 14 Spares List 2
- Eclipse 4 PAGE 15 Spares List 3
- Eclipse 4 PAGE 16
- Eclipse 4 PAGE 17
- Eclipse 4 PAGE 18
- Eclipse 4 PAGE 19 Option Parts
- Eclipse 4 PAGE 20 Car Settings
- Eclipse 4 PAGE 21 Car Settings
- Eclipse 4 PAGE 22 Car Settings
- Eclipse 4 PAGE 23 Car Settings
- Eclipse4_Setup_Blank
- Eclipse4_Setup_High_Grip
1 Dot
Low
Position
3 Dot
High
Position
2 Dot
Medium
Position
Mark and drill your body
to diameter 6.5mm for the
body posts.
Select the correct body
washer to fine tune the
bodyshell height.
Each incremental change
is 1.2mm.
Select the correct pin height
for your bodyshell.
Snap the body washers
onto the pins.
The bodyposts may be trimmed for
looks and aerodynamics. A sharp
knife or side cutters may be used.
Alternatively use AM190041 -
Arrowmax Body Post Trimmer
Attach R-clips after
body washers.
The foam bumper has a chamfered front edge.
This allows the bodyshell to be mounted directly
on top of it, removing the need to use the body
washers and increasing durability.
It is also the correct height for most bodyshells.
M3 x 10
x 2
M3 x 10
x 2
ΓΈ1.5 x 11.8
x 4
Page 16
Step 17