User Manual
• 5 •
5. CHARGING
IMPORTANT! CHARGE THE WORK LIGHT IMMEDIATELY AFTER PURCHASE,
AFTER EACH USE, AND AT LEAST EVERY 6 MONTHS. Failure to do this will
reduce the battery’s capacity and may void the warranty.
5.1 Connect the micro USB end of the charging cable to the micro USB port on the back
of the work light. Insert the USB end of the cable into the USB port on your charger.
5.2 Plug your charger into a live power source.
5.3 The charge level LEDs will ash green and show the level of charge.
5.4 When the battery is fully charged, all ve LEDs will be solid green.
5.5 Recharge the work light after use, and at least every 6 months.
6. OPERATING INSTRUCTIONS
6.1 Hang the work light, using the hook on the end. Pull out the base from the main
body of the work light to rotate 360°, for more precise positioning.
6.2 The magnet may be used instead. Attach the magnetic end of the work light to
any ferrous metal surface.
6.3 Direct the lens away from your eyes before turning on the work light.
6.4 To turn on the side SMD LEDs, turn the switch clockwise. Continue turning, to
increase the brightness. To shut off, turn the switch in the opposite direction.
6.5 Press the power button to turn the end LED on and off.
6.6 Recharge the work light after use, and at least every 6 months. VOTING
7. MAINTENANCE INSTRUCTIONS
7.1 After use and before performing maintenance, unplug and disconnect the work light.
7.2 Use a dry cloth to wipe any dirt or oil from the charging cable and case.
7.3 Ensure that all of the work light’s components are in place and in good working
condition.
7.4 Servicing does not require opening the unit, as there are no user-serviceable parts.
7.5 Any servicing should be performed by qualied service personnel.