Owner`s manual

4001/2-J, 4N11/2-J Manual
IM061103
RD: Aug 2006
R.L. 08B
KH
5. ASSEMBLY INSTRUCTIONS
Fasten the post to the top of the post
brackets, aligning pre-drilled holes as
shown.
Use six M6 x 35mm bolts, washers &
nuts to attach post to post brackets.
Tighten securely
.
Page 8
Attach Wheel Kit to base:
Assemble wheel brackets to base ‘L’ brackets using four #8 x
3/4” bolts and nuts (Note: Bolt heads face the wheel; Position
wheel brackets with curve “up”)
Align pairs of holes in each end of ‘L’ brackets to those in
opposite sides of the base - fasten in place with #8 x 3/4”
bolts & nuts. (NOTE: Position wheel brackets with curve “up”)
Assemble wheels to wheel brackets using axle bolts & nuts
NG Model Only: Install #10 x 1 1/4” bolt up though the hole in
top of cylinder base - opposite the wheel assemblies
 Place washer on bolt
 Insert up through hole in top surface of base
 Fasten with washer and nut
 Finger tighten the second nut in place for later use
Wheel brackets curve ‘up’
Attach the 3 post mounting brackets to the
Cylinder Base as shown.
Use three M8 x 15mm bolts to secure
brackets to the base