User guide

ManualsBrandsSchwank ManualsHardwareDecorative Tuxedo Grille Kit

Tuxedo Grill I&O Manual

IM090417

RD: April 2009

RL: 01

INSTALLATION INSTRUCTIONS

DECORATIVE TUXEDO GRILLE KIT

TG-0010-KT

NOTE: THIS ACCESSORY WILL FIT TO TUBE HEATER MODELS:

Schwank: STS-JZ, STR-JZ, STW-JZ, SPW-JZ

InfraSave: IQ, IW, IWP

Summary of content (5 pages)

PAGE 1
INSTALLATION INSTRUCTIONS DECORATIVE TUXEDO GRILLE KIT TG-0010-KT NOTE: THIS ACCESSORY WILL FIT TO TUBE HEATER MODELS: Schwank: STS-JZ, STR-JZ, STW-JZ, SPW-JZ InfraSave: IQ, IW, IWP Tuxedo Grill I&O Manual IM090417 RD: April 2009 RL: 01 BA
PAGE 2
NOTICE: The Manufacturer reserves the right to make changes to equipment and specifications without obligation or notification. This publication, or parts thereof, may not be reproduced in any form, without prior written consent from The Manufacturer. Unauthorized use or distribution of this publication is strictly prohibited.
PAGE 3
GENERAL NOTES: 1. The Tuxedo Grille accessory kit can be attached only to TS-xxxx-JZ tube kits 2. Begin installation of the kit always at the burner end of the heater 3. The following instructions are for the first ten foot section, repeat the process for each additional 10 ft kit 4. Handle components with care to prevent scratching or mis-shaping TOOLS REQUIRED: The Tuxedo Grille kit required only a set of needle-nose pliers for installation The Tuxedo Grille includes the following components: 1.
PAGE 4
3. Install 5 ft side rail - Continued:  Press the side rail firmly “up” into place  Using pliers, bend the tab nearest the end over the bottom ‘V’-lip of the reflector to secure one end of side rail in place  Repeat at other end of the side rail Reflector Bend end tabs over reflector ‘V’-lip  NOTE: at this stage, secure only the tab near each end of the side rail - this will secure the side rail in place, but allow easy realignment adjustment if required 4.
PAGE 5
9. Install next 5 ft side rail  Insert end tab of side rail trough slots in cross pieces  Tabs fit inside of end tabs from first side rail  Hold side rail in place and bend the top tab (near opposite end from cross pieces) over the reflector ‘V’-lip to hold side rail in place  Bend the top tab at the end near the cross pieces over the reflector ‘V’-lip to secure the side rail in place  Repeat procedure for the side rail on the opposite side of the reflector 10.