Electric Manual

ManualsBrandsSchwank ManualsCooling & Air QualityElectric Indoor/Outdoor 39" 2000 Watt Patio Heater

SAVE THIS MANUAL FOR FUTURE REFERENCE

Page

Warnings - IMPORTANT - Read First 2

Installation Instructions 3

Specications 3

Wiring Instructions 3

Mounting Instructions 4

Replacement Element Installation 5

Replacement Parts 5

Heater Coverage Areas 6

General Notes 6

Maintenance Instructions 6

Troubleshooting 7

Location Suggestions 7

Warranty 8

For warranty purposes and ordering replacement parts, record the following information:

Model #: _________________________________________ Serial #: ____________________________________________

Date of Purchase: _________________________________ Purchased From: _____________________________________

patioSchwank

electricSchwank Series

EL/ELD Series

QUARTZ ELECTRIC INFRARED RADIANT HEATER

For Indoor/Outdoor Use: Patios, Spectator Venues, Commercial/Industrial Spaces

INSTALLATION MANUAL

Electric I&O Manual IM111116 RL:2A AUG 2018

Summary of content (8 pages)

PAGE 1
patioSchwank electricSchwank Series EL/ELD Series QUARTZ ELECTRIC INFRARED RADIANT HEATER For Indoor/Outdoor Use: Patios, Spectator Venues, Commercial/Industrial Spaces INSTALLATION MANUAL Page Warnings - IMPORTANT - Read First 2 Installation Instructions 3 Specifications 3 Wiring Instructions 3 Mounting Instructions 4 Replacement Element Installation 5 Replacement Parts 5 Heater Coverage Areas 6 General Notes 6 Maintenance Instructions 6 Troubleshooting 7 Location Suggestions 7
PAGE 2
WARNINGS READ ALL INSTRUCTIONS BEFORE USING HEATER Unit may be a source of possible shock. NEVER attempt to service heater without disconnecting its power source. Source of possible ignition - maintain clearances from combustible materials. WARNING: If not installed, operated and maintained in accordance with the manufacturer’s instructions, this product can expose you to chemicals including nickel, which are known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.
PAGE 3
INSTALLATION INSTRUCTIONS This heater must be permanently installed and hard wired by a licensed electrician in accordance with local electrical codes. Assembly procedure must be performed with no electrical power to unit. Step 1: Check UL/CUL/CE rating label on heater for proper voltage. Step 2: Follow supplied wiring instructions. [See wiring instructions below] Step 3: Heater must be mounted with reflector angled down [maximum 60° from horizontal].
PAGE 4
MOUNTING MOUNTING INSTRUCTIONS INSTRUCTIONS These These models models may may be be chain chain or or bracket bracket mounted mounted to to any any ceiling ceiling or or horizontal horizontal surface. surface. Installation Installation must must be be such such that 18" [45.7 cm] minimum clearance is maintained around the heater on all 4 sides and 36" [91.4 cm] directly in front/ that 18" [45.7 cm] minimum clearance is maintained around the heater on all 4 sides and 36" [91.4 cm] directly below.
PAGE 5
REPLACEMENT ELEMENT INSTALLATION Disconnect the power at the breaker. Remove the grill by grasping it in the middle, flex grill up and lift it off. Unscrew and remove both end reflectors. Unhook element clips at each end of the heater and remove nuts from end of element to remove the existing Quartz. Carefully install the new element. Remove one nut from end of the new element. Install wire by sliding high temperature ring terminal onto element screw and replace nut.
PAGE 6
SINGLE ELEMENT TYPICAL AREA COVERAGE - feet [m] PART NUMBER WATTS MOUNTING HEIGHT AVERAGE COLD PROTECTED ES/EL-1533-20 1,500 6' - 8' [1.8 m - 2.4 m] 5' x 5' [1.5 m x 1.5 m] 3' x 3' [.91 m x .91 m] 7' x 7' [2.1 m x 2.1 m] ES/EL-2039-24 2,000 7' - 9' [2.1 m - 2.7 m] 6' x 6' [1.8 m x 1.8 m] 4' x 4' [1.2 m x 1.2 m] 8' x 8' [2.4 m x 2.4 m] ES/EL-2539-24 2,500 7' - 9' [2.1 m - 2.7 m] 7' x 7' [2.1 m x 2.1 m] 5' x 5' [1.5 m x 1.5 m] 9' x 9' [2.7 m x 2.7 m] ES/EL-3061-24 3,000 7' - 9' [2.
PAGE 7
TROUBLESHOOTING PROBLEM WHAT TO DO Heater does not glow ▪ Check supply voltage to confirm it matches voltage of heating element. Low heat output ▪ A 240V element connected to 110V or 208V will warm, but not glow orange or generate sufficient heat for typical applications [Matching your voltage is extremely important]. If element is visibly orange, but there is insufficient heat, refer to the areas covered with respect to conditions and mounting heights.
PAGE 8
LIMITED PRODUCT WARRANTY Important: Please retain original proof of purchase to establish warranty period. electricSchwank and EL/ELD Series Electric Powered Radiant Heaters: The Manufacturer warrants that this product is free from defects in material or workmanship under normal use and service subject to the terms of this document.