Arm Wall Mounting Kit

GP-MMAK-CX-04A

2100/2300 Mounting Arm Kit Manual

AUG 2021

RL: 1A

Tel 1-877-686-3779 | www.schwankgroup.com

JP-2300-MK ARM WALL MOUNTING KIT

MOUNTING ARM AND HEATER BRACKET

HEATER BRACKET FASTENS TO MOUNTING ARM

WITH 2 EACH NUTS & BOLTS SUPPLIED

WARNING: Ensure that anchoring to the structure (field sup-

plied anchor hardware) is of sufficient strength, in-

tegrity and workmanship, to adequately support the

weight of the heater and any other potential loads

such as snow build up and wind.

• See next page for assembly of heater bracket to mounting arm for desired heater

orientation at horizontal or 30° angle

• Mounting arm dimensions on page 3

ALLOWS MOUNTING OF HEATER:

• 27.5” FROM MOUNTING SURFACE

• EITHER HORIZONTAL

• OR AT 30° ANGLE (MAXIMUM)

Six anchor

points

PAGE 1
JP-2300-MK ARM WALL MOUNTING KIT MOUNTING ARM AND HEATER BRACKET ALLOWS MOUNTING OF HEATER: • 27.5” FROM MOUNTING SURFACE • EITHER HORIZONTAL • OR AT 30° ANGLE (MAXIMUM) Six anchor points HEATER BRACKET FASTENS TO MOUNTING ARM WITH 2 EACH NUTS & BOLTS SUPPLIED WARNING: Ensure that anchoring to the structure (field supplied anchor hardware) is of sufficient strength, integrity and workmanship, to adequately support the weight of the heater and any other potential loads such as snow build up and wind.
PAGE 2
NOTE: MOUNT HEATER AT MAXIMUM 30° ANGLE Using pairs of holes in the heater bracket allows heater orientation: • Horizontal • Angled at 30° (MAXIMUM angle mount) Anchor holes (bracket pivot point) Assemble Mounting Bracket to Mounting Arm using bolts and nuts supplied: • Align the anchor holes in the heater bracket and the mounting arm, and insert a bolt • Finger tighten nut on to bolt to allow rotation of the heater bracket • Align the desired mounting angle holes in the heater bracket to the outermost