Owner`s manual

Remote Control Manual

IM060930

RD: SEPT 2006

RL: 03A

SPW / IWP Tube Heater Series

RECEIVER INSTALLATION (Continued)

FIGURE 5

10. Remove the protective backing from one set of the

Velcro strips provided to reveal the adhesive

11. Attach one Velcro strip to the inside surface of the

burner housing side panel—Press firmly in place

 NOTE: Locate Velcro so that the mounted receiver

will not come into contact with existing burner

components when the side panel is reattached

12. Attach the mating Velcro strip to the back side of

the Receiver—press Velcro firmly in place

FIGURE 6

13. Program the receiver by setting the ‘House Code’ and

‘Group Code’ dial switches to the correct setting for that

particular heater or zone (see pages 4, 5)

14. Attach the Receiver to the Velcro strip on the inside surface

of the housing side panel

FIGURE 4

6. Insert the wires provided into the Receiver unit

as per Wiring Diagram (next page).

7. Remove (snip off) any female spade connectors

from wires from the receiver

8. Connect wires to the terminal block on the com-

ponent plate as indicated in the Wiring Diagram

(next page)

9. Replace component plate in the burner housing,

align with holes in the end of the housing

10. Fasten component plate in place with two screws

at the end of the housing

15. Reattach the side panel to the burner housing

16. OPTIONAL: For secure storage of the Transmitter,

attach second set of Velcro strips to the back of the

Hand Set Transmitter and at a convenient site loca-

tion.