Owner`s manual

Remote Control Manual

IM060930

RD: SEPT 2006

RL: 03A

9. Reinstall the Component Access Door on the heater

10. OPTIONAL: For secure storage of the Transmitter, attach sec-

ond set of Velcro strips to the back of the Hand Set Transmitter

and at a convenient site location.

RECEIVER KIT INSTALLATION - JP-1234-RK

patioSchwank 2300 / IO-210 Series

FIGURE 2

4. Remove the protective backing from one set of the Velcro strips

5. Attach one Velcro strip to the inside surface of the Heater - Press

Velcro firmly in place

 NOTE: Locate Velcro so that the mounted receiver will

not come into contact with existing burner components

6. Attach the mating Velcro strip to the back side of the Receiver -

press Velcro firmly in place

FIGURE 3

7. Program the receiver by setting the ‘House Code’ and ‘Group Code’ dial

switches to the correct setting for that particular heater or zone (see pages

4, 5)

8. Attach the Receiver to the Velcro strip on the inside surface of the heater

 Read the Programming / Setup section (pages 4 & 5) prior to installation of the receiver into a heater.

 Complete the “Patio Floor Plan sketch and Settings Table” on the last page of this manual to assist you

in the installation & programming process.

 Refer to the wiring diagrams (next page) in this manual for electrical connection of the receiver to the heater

ignition system.

NOTE: We recommend the installation of an External Manual Over-ride Switch to allow temporary operation of

the heater(s) if the Hand Set Transmitter is misplaced or malfunctions. (Refer to Wiring Diagram)

The Manual Over-ride Switch must be in the ‘Off” position for the remote control system to operate

FIGURE 1

1. Remove Control Access Door

2. Insert/fasten wires into receiver (see Wiring Diagram - next page)

3. Connect wires from the receiver to the heater (see Wiring Diagram -

next page)