Installation and Operation Guide
Page 12
4. Installation
Step 3
Fit the undermount in place, using the installation screws
provided (E).
Step 4
Only install the reducer if you are connecting the rangehood to the
Isodrive 650 motor. DO NOT install the reducer for any other motor
system.
Step 5
Once the rangehood is tted into the cabinetry, connect the male and female
power connections to the corresponding connections. Male to main power,
female to Isodrive motor. The exi ducting will attach to the outlet on the
rangehood and the Isodrive motor.
Note: The electronics need to be accessible after installation, in case a service
is required.
Protecting the Cabinet Door — Optional
A reversible “L” shaped prole is provided for optional cabinet
door (D) protection.
D
E
“L” shaped
prole
Male power plug
connects to mains
Electronic control
system
Female power plug
connects to the
Isodrive motor
Reducer to be connected to the 200mm
opening (Isodrive 650 motor only)